Pipe fittings, Butt-Welded,  Stainless Steel Pipe Fittings, Elbows, Tees, Reducers, Stubends , Endcaps
Stainless Steel
Coils & Foils, Pipes & Tubes

PIPE FITTINGS

BFTL manufactures high quality Butt-Welded Fittings in Stainless Steel as per International and National Standards.
The range of pipe fittings offered includes Elbows, Tees, Reducers, Stubends and Endcaps. Elbows: 45 Degree and Long & Short Radius 90 Degree Elbows and 180 Degree Return Bends Enables the pipe run to be turned through 45degrees, a right angle or back onitself.

Long Radius : Radius is 1.5 times nominal pipe size.
Short Radius: Radius is the sameas the nominal pipe size.

Equal Tee: Allows connection of a branch at right angles from main pipe run. Branch has same dimensions as main pipe run.

Reducing Tee: Allows connection of a branch at right angles from main pipe run. Branch has smaller dimensions than main pipe run. When stating the size, the larger dimension always specifies the main pipe run, no matter which order the dimensions are quoted in.

Concentric Reducer: Used to connect two pipes of different dimensions. Designed to have good flow characteristics thus reducing erosion and corrosion.

Eccentric Reducer: Used to connect two pipes of different sizes.Has one straight side allowing pipe run to stay flat against a wall and may be preferred for some flows.

End Cap: Used to blank off at the end of pipework.

Stub End: NB: Made to MSS SP43 Always used with a Lap Joint Flange as a backing flange. Flange can be made of coated mild steel as it does not come into contact with the product in the pipe.This is a cheap method of
flanging in low-pressure, non critical applications.

Material

Stainless Steel

Grades : SS 304 / 304L/316/316L/317/317L/321/310 etc.
Manufacturing Standards – ASTM/ASME SA 403
Dimensional Standards – ASME B 16.9, B 16.11
Sizes: ½” to 24”
Sch – Sch 5s to Sch 40s

© Bhandarigroup.in    Contact Us | Feedback | Sitemap